I needed to mount a pair of cameras on my exterior, and came up with a low profile mounting plate that would require only 1 cable hole for both cameras. By doing this, I was able to minimize the number of holes in my stucco wall. But to keep it low profile, I need a 25mm.1″ hole minimum in my wall to pass the Hikvision CAT5E connector seal.
The design started off as a personal project for a side of my residence where I needed to mount 2 cameras.
I actually designed the plate to support a 3rd camera in the middle, so the design is longer than needed
Once designed, I had the plates manufactured at a local tool & die machine shop, from aircraft grade 6061-T6.
It took a few weeks for them to get made. When they were ready, I picked up the parts, covered with…
View original post 289 more words